AirSep FreeStyle Manuel Du Patient page 221

The FreeStyle is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of the
FreeStyle can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications
equipment (transmitters) and the FreeStyle as recommended below, according to the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be estimated using the
equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in Watts (W) according to the
transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures,
objects and people.
The FreeStyle is intended for use in the electromagnetic environment specified below. The customer or the user of the FreeStyle should assure
that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
MN131-1 rev C
Recommended separation distances between portable and mobile RF
communications equipment and the FreeStyle
Separation distance according to frequency of transmitter
from 150kHz to 80MHz
d= 1.2 x √P
0.12
0.38
1.2
3.8
12
Guidance and manufacturer's declaration - electromagnetic emissions
Compliance
The FreeStyle uses RF energy onl
Group 1
y for its internal function. Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
Class B
The Freestyle is suitable for use in all establishments, including domestic establishments
Class A
and those directly connected to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Complies
(m)
from 80MHz to 800MHz
d= 1.2 x √P
0.12
0.38
1.2
3.8
12
Electromagnetic Environment guidance
from 800MHz to 2.5GHz
d= 2.3 x √P
0.23
0.73
2.3
7.3
23
EN-39