Arneg H216 Mode D'emploi page 39

5 Loosen the screws that fix the anti-
fraying fork on the upper part of the
door. Let the fork slide and rotate it as
indicated in figure A:
6 In order to remove the door, it must be
lifted and simultaneously rotated as
indicated in the drawing so that it is
first released from its housing on the
bottom part.
Given the weight of the door the col-
laboration of two workers is recom-
mendedl.
N.B.If difficulties are encountered
while removing the door, use a
lever in wood or other similar
material so not to damage the
door itself. Delicately lift the door
a few millimetres so as to
withdraw the pin of the lower
hinge.
Do not exert unneccessary force
7 Remove the door and place it on a flat
horizontal surface so as to carry out
the inversion operation in the best way
possible..
Fully remove the entire lower hinge
unit.
A) Remove the screws (1) and (2)
using the respective spanners
B) Remove the lower hinge uni
C) Withdraw everything, including the
galvanised block
D) Dismantle the galvanised block unit
(3)
E) Remove the elastic ring that holds
the sleeve in place (4) using the appro-
priate pliers
F) Remove the lower pin-guide sleeve
(5)
05060130 00 26/04/2012
A
A
(2)
D
(3)
A
B
(1)
E
(4)
Wengen
English
C
(3)
F
(5)
39