Arneg H216 Mode D'emploi page 31

lower weight than the cabinet
unsuitable characteristics or ones altered by use.
invalid or worn out ropes or wires
Transport procedures different than those pointed out are not allowed
8. Storage
DO NOT store the cabinets in uncovered areas and therefore subjected to
atmospheric agents and to direct sunlight. Exposure to ultraviolet rays causes
permanent deformation of the plastic materials and damages cabinet components.
The cabinets must be stored in indoor environments that are dry and humidity-free
and that have a temperature ranging between -25°C and + 55°C and a humidity
between 30% and 90%.
Before storing the cabinets, check that the packing is intact and that it does not
display defect that may compromise preservation of the cabinets.
9. Receiving, unpacking, first cleaning - qualified operator -
Before any unpacking operation, adopt all the precautions possible to avoid injuries to
the operator.
The cabinet can be supplied packed as described below:
With frame in wood fixed to the base and nylon casing blocked by straps (standard)
(Rif. 7).
With a cardboard casing (on request) (Rif. 8).
With cage in wood (on request) (Rif. 9).
When receiving the cabinet:
Make sure the packing is intact and that it does not display readily apparent
damages;
Carefully perform the unpacking operation in order not to damage the cabinet;
Check the integrity of the cabinet components;
In case you detect damages, immediately call the supplier;
Slowly remove the protective films without tearing them, to avoid glue residues; the
residues can be removed with appropriate solvents.
Proceed with a first cleaning using neutral products and dry with a soft cloth; do not
use abrasive substances or metallic sponges;
To correctly dispose of the packing, bear in mind that it is made up of: Wood -
Polystyrene - Polythene - PVC - Cardboard.
DO NOT use alcohol to clean the parts in methacrylate (Plexiglas).
During the unpacking operations, do not leave elements of the packing
unattended such as nails, wood, gripper rods, nylon, etc. and tools used for
the operation such as pliers, scissors, pincers, in the work area, which could
cause wounds and injuries.
These objects must be removed with appropriate means and brought to their
respective collection places.
10.Installation and environmental conditions - specialized technician -
Any modification to the installation described herein must be authorized by
ARNEG Spa
To ensure that the technicians appointed to installation may operate safely, we
recommend to use the instruments and protection clothing required by the safety
norms or by the laws in force in the country of installation. At any rate, always use
adequate equipment and clothing, such as: anti-injury boots, protection gloves,
spirit level.
The cabinet has been designed to exclusively operate in indoor environments.
For the installation, adhere to the following:
carefully examine the installation area, eliminating any danger to the operator;
Do not position the cabinet:
05060130 00 26/04/2012
Wengen
English
31