Limit Setup With A Remote Control - LiftMaster Elite Serie Manuel D'installation

Limit Setup with a Remote Control

To set the limits using a remote control, first you will need a 3-button remote control that has been programmed for OPEN, CLOSE, and STOP. Refer to the
Programming section.
Initial Limits and Force Adjustment
The gate/door MUST be attached to the operator before setting the
limits and force.
Ensure the gate/door is closed.
1. Press and release the SET OPEN and SET CLOSE buttons
simultaneously to enter limit setting mode.
2. Press and hold the OPEN or CLOSE button on the remote control
until the gate/door reaches the desired open position. The gate/door
can be jogged back and forth using the OPEN and CLOSE buttons on
the remote control.
3. Once the gate/door is in the desired open position, press and release
the STOP button on the remote control.
4. Press and release the OPEN button on the remote control again to
set the open limit.
5. Press and hold the CLOSE or OPEN button on the remote control
until the gate/door reaches the desired close position. The gate/door
can be jogged back and forth using the OPEN and CLOSE buttons on
the remote control.
6. Once the gate/door is in the desired close position, press and release
the STOP button on the remote control.
7. Press and release the CLOSE button on the remote control again to
set the close limit.
8. Cycle the gate/door open and close. This automatically sets the force.
When limits are set properly the operator will automatically exit limit
setting mode.
Refer to the Adjustment section and follow the instructions for Fine Tune
the Force and Obstruction Test . Perform the "Obstruction Test" after every
limit and force setting adjustment.
PROGRAMMING
Adjust the limits
If the limits have already been set the operator will exit the limit setting
mode after resetting each limit.
Set the Close Limit Only
1. Press and release the SET OPEN and SET CLOSE buttons
2. Press and hold the CLOSE button on the remote control until the
3. Once the gate/door is in the desired close position, press and release
4. Press and release the CLOSE button on the remote control again to set
When the close limit is set properly the operator will automatically exit limit
setting mode.
Set the Open Limit Only
1. Press and release the SET OPEN and SET CLOSE buttons
2. Press and hold the OPEN button on the remote control until the
3. Once the gate/door is in the desired open position, press and release
4. Press and release the OPEN button on the remote control again to set
When the open limit is set properly the operator will automatically exit limit
setting mode.
DIAGNOSTICS
22
simultaneously to enter limit setting mode.
gate/door reaches the desired close position. The gate/door can be
jogged back and forth using the OPEN and CLOSE buttons on the
remote control.
the STOP button on the remote control.
the close limit.
simultaneously to enter limit setting mode.
gate/door reaches the desired open position. The gate/door can be
jogged back and forth using the OPEN and CLOSE buttons on the
remote control.
the STOP button on the remote control.
the open limit.
3-Button Remote Control programmed for OPEN, CLOSE, and STOP