Remote Control - LiftMaster 8550C Mode D'emploi

Remote Controls
Your garage door opener has been programmed at the factory to operate with your remote control. To program additional remote controls refer to the instructions provided with the additional remote controls
or visit www.liftmaster.com.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE DOOR CONTROL
1
Press the navigation button
below "MENU" to view the
Features menu.
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON
2 3
Use the navigation buttons
to scroll to "PROGRAM".
press
press to continue.
1
Locate the Learn button on the garage door opener. NOTE: Your garage
door opener may look different.
Select "REMOTE" or 4

Remote Control:

"KEYPAD" to program from
Press the button on the remote control that you wish to operate your
the program menu.
garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on
to continue.
the keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when
TO REMOTE
the code has been programmed.
Repeat the steps above for programming additional remote controls or
keyless entry devices. If programming is unsuccessful, program the
remote using the learn button.
Learn
E L D
Yellow
32
2
Locate the Program Button on the side of the remote control.
Program Button
OR
? ? ? ?
PIN