Remote Control - LiftMaster ELITE Série Mode D'emploi

Remote Control

Your remote control has been programmed at the factory to operate with your garage door opener.
Older LiftMaster remote controls are NOT compatible, see page 37 for compatible accessories. Programming can be done through the door control or the learn button the garage door opener. To program
additional accessories refer to the instructions provided with the accessory or visit www.liftmaster.com. If your vehicle is equipped with a Homelink
make, model, and year of your vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE DOOR CONTROL
1
Press the navigation button
below "MENU" to view the
Features menu.
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON ON THE GARAGE DOOR OPENER
2 3
Use the navigation buttons
to scroll to "PROGRAM".
press
press to continue.
1
Locate the Learn button on the garage door opener. NOTE: Your garage
door opener may look different.
Select "REMOTE" or
4
Remote Control:
"KEYPAD" to program from
Press the button on the remote control that you wish to operate your
the program menu.
garage door.
Keyless Entry:
to continue. Enter a 4-digit personal identification number (PIN) of your choice on
the keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when
TO REMOTE
the code has been programmed.
Repeat the steps for programming additional remote controls or keyless
entry devices. If programming is unsuccessful, program the remote using
the learn button.
Learn
E L D
Yellow
32
®
, you may require an external adapter depending on the
2
Locate the Program Button on the side of the remote control.
Program Button
OR
? ? ? ?
PIN