To Erase The Memory - LiftMaster ELITE Série Mode D'emploi

Remote Control
3
Using a safety pin or paper clip, press the
program button until the LEDs on the front of
the remote control turn on.
6
To exit programming mode, press any remote control button except the button that was just
programmed.

To Erase the Memory

4
Press and release the Learn button on the
garage door opener. The Learn LED will light.
Within 30 seconds...
5
Press and release the remote control button you want to use...
Check to see if the garage door opener light bulb blinks. If not, wait for the remote control LED to
light solid then slowly press and release the remote control button again.
Repeat until the light bulb blinks. DO NOT press the button after the light bulb blinks.
7
To test, press the programmed button on the remote control... The garage door opener will
activate.
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1
Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ
1
Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2
Immediately press and hold the learn button again until the learn LED goes out. All codes are
now erased.
Reprogram any accessory you wish to use.
33
® enabled accessories)