LiftMaster ELITE Série Mode D'emploi page 9

3
Attach the rail to the header bracket
3.1
Align the rail with the header bracket.
Insert the clevis pin through the holes in
the header bracket and rail. Secure
with the ring fastener.
NOTE: Use the packing material as a
protective base for the garage door opener.
4
Position the garage door opener
To prevent damage to garage door, rest garage
door opener rail on 2x4 placed on top section of
door.
Ring
Fastener
Clevis Pin
5/16" X 2-3/4"
4.1
Remove the packing material and lift the
garage door opener onto a ladder.
NOTE: A 2x4 is ideal for setting the distance
between the rail and the door. If the ladder is
not tall enough you will need help at this point.
HARDWARE
Clevis Pin
5/16" x 2-3/4"
4.2
Fully open the door and place a 2x4 (laid flat) under the rail.
NOTE: If the door hits the trolley when it is raised, pull the trolley release arm down to
disconnect the inner and outer trolley. Slide the outer trolley toward the garage door opener.
The trolley can remain disconnected until instructed.
Connected Disconnected
9
Ring Fastener