LiftMaster ELITE Série Mode D'emploi page 13

9 Connect the door arm to the trolley
IMPORTANT: The groove on the straight door arm MUST face away from the curved door arm.
CORRECT
Straight
INCORRECT
Door Arm
Curved
(Groove Door
facing out)
Arm
Straight
Door
Arm
Curved
Door
Arm
HARDWARE
Hex Bolt 5/16"-18x7/8"
Clevis Pin
5/16"x1"
Nut
5/16"-18
Ring Fastener
Lock
Washer
5/16" Clevis Pin 5/16"x1-1/4"
9.1
Close the door. Disconnect the trolley by
pulling the emergency release handle.
Slide the outer trolley back (away from
the door) about 2" (5 cm).
9.4
Align the straight door arm with the
curved door arm. Select two aligned
holes (as far apart as possible) and
attach using the bolts, nuts and lock
washers.
Nut 5/16 - 18
"
Lock
Washer
5/16
"
Hex Bolt
5/16 - 18 x 7/8"
"
9.2
Attach the straight door arm to the outer
trolley using the clevis pin. Attach with
the ring fastener.
Clevis Pin
Ring
5/16 " x 1"
Fastener
NOTE: If the holes do not line up, reverse the
straight door arm. Select two aligned holes (as
far apart as possible) and attach using the
bolts, nuts and lock washers.
Nut 5/16 " - 18
Lock
Washer
5/16
"
Hex Bolt
5/16 - 18 x 7/8"
"
If the straight door arm is hanging
down too far, you may cut 6 inches
(15 cm) from the solid end.
13
9.3
Attach the curved door arm to the door
bracket using the clevis pin. Attach with
the ring fastener.
Ring
Fastener
Clevis Pin
5/16
" x 1-1/4"
9.5
Pull the emergency release handle
toward the garage door opener until the
trolley release arm is horizontal. The
trolley will re-engage automatically when
the garage door opener is activated.
Trolley
release arm