Remote Controls - LiftMaster Security+2.0 myQ T Mode D'emploi

PROGRAMMING
To prevent possible SEVERE INJURY or DEATH:
• Install a LiftMaster Monitored Entrapment Protection (LMEP)
Device.
• NEVER wear watches or rings when opening or inside of the
enclosure with power on.
• Avoid contact with any wiring or connection points inside of
the enclosure.
• ALWAYS use only one hand inside of the enclosure when
pressing buttons on the printed circuit logic board.

REMOTE CONTROLS

Built in 3-channel, Security+2.0
NOTE: The following programming requires a LiftMaster Monitored Entrapment Protection (LMEP) Device.
SINGLE BUTTON REMOTE CONTROL
1
Press and release the RADIO button (RADIO
LED will light).
OLS
MID
SLS
CLS
MRT MID
RADIO 1
T
E2
D1
C2
B2
3-BUTTON REMOTE CONTROL TO OPERATE AS A WIRELESS 3-BUTTON CONTROL STATION
RELAY
RELAY
NOTE: The feature will use 3 of the 90 memory channels in the operator.
OLS
1 MID
Press and release the RADIO
SLS
button on the logic board
(the Radio LED will light).
CLS
OLS
MID
SLS
RADIO
CLS
MRT MID TTC
RADIO 1 2 3
T TS
E2
FSTS
Repeat steps 1 through 4 to program additional buttons.
D1
DIAG
C2
OPTN
PROG
B2
TO ERASE ALL REMOTE CONTROLS
RELAY A
RELAY B
1
Press and hold the RADIO button on the logic board until the RADIO LED flashes
rapidly (approximately 5 seconds). All remote controls will be erased.
OLS
MID
SLS
CLS
RADIO
radio receiver allows you to add up to 90 remote control devices and up to 30 keyless entry devices.
®
DATA
2
Press and hold the remote control button until the
14
24VAC
RADIO LED flashes rapidly, then release remote
POWER
13
24VAC
control button. The RADIO LED will then remain on
12
TIMER
DEFEAT
solid after releasing the button. Repeat to add
11
COMMON
additional remote control(s).
MAS
10
9
LMEP:
TTC TIMER
EDGE: 8
ENABLE
OPEN
7
2 3
CLOSE
6
5
STOP
TS
FSTS
4
COMMON
DIAG
3
OPTN
24VAC
DATA
PROG
2
POWER
1
24VAC
SBC
A
B
TIMER
DEFEAT
COMMON
2
Press and release the desired button on the MAS
14
24VAC
logic board (OPEN, CLOSE or STOP). The
POWER
13
Radio LED will flash and then stay on solid.
24VAC
LMEP:
12
TIMER
DEFEAT
MRT MID TTC TIMER
EDGE:
ENABLE 11
COMMON
OPEN
MAS
10
1 2 3
9
LMEP: CLOSE
TIMER
EDGE: 8
ENABLE
OPEN
STOP
7
T TS
E2
FSTS
CLOSE
6
COMMON
D1
DIAG
5
STOP
DATA
C2
OPTN
4
PROG
COMMON
B2
3
2
SBC
RELAY A
RELAY B
1
SBC
14
24VAC
POWER
13
24VAC
12
TIMER
DEFEAT
11
COMMON
MAS
10
9
LMEP:
MRT MID TTC TIMER
8
EDGE:
ENABLE
OPEN
7
1 2 3
CLOSE
6
5
STOP
T TS
E2
FSTS
4
COMMON
D1
DIAG
3
C2 OPTN
PROG
B2
2
1
SBC
RELAY A
RELAY B
• NEVER permit children to operate or play with door control
push buttons or remote controls.
• Activate door ONLY when it can be seen clearly, is properly
adjusted and there are no obstructions to door travel.
• ALWAYS keep door in sight until completely closed. NEVER
permit anyone to cross the path of closing door.
DATA
14
13
12
11
3
Press and hold the desired button
10
of the remote control until Radio
LED flashes rapidly, then release.
9
8
7
6
5
4
3
2
1
NOTICE: To comply with FCC and/or Industry Canada (IC) rules, adjustment or modifications of this
transceiver are prohibited. THERE ARE NO USER SERVICEABLE PARTS. Any changes or modifications
not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment. This device complies with Part 15 of the FCC rules and IC RSS-210. Operation
is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired
operation. This Class B digital apparatus complies with Canadian ICES-003. This device must be
installed in a way where a minimum 8" (20 cm) distance is maintained between users/bystanders
and device.
4
3
Press and release the RADIO button to complete the
programming. The programming mode is exited if no
activity is performed within 30 seconds.
OLS
MID
SLS
CLS
MRT
RADIO 1
E2
D1
C2
B2
4
Press and release the RADIO button to
complete the programming. The
programming mode is exited if no activity
is performed within 30 seconds.
RADIO
DATA
14
24VAC
POWER
13
24VAC
12
TIMER
DEFEAT
11
COMMON
MAS
10
9
LMEP:
MID TTC TIMER
8
EDGE:
ENABLE
OPEN
7
2 3
CLOSE
6
5
STOP
T TS
FSTS
4
COMMON
DIAG
3
OPTN
PROG
2
1
SBC
RELAY A
RELAY B
24VAC
POWER
24VAC
TIMER
DEFEAT
OLS
COMMON
MID
MAS
SLS
CLS
LMEP:
MRT MID TTC TIMER
EDGE:
ENABLE
OPEN
1 2 3
CLOSE
STOP
T TS
E2
FSTS
COMMON
D1
DIAG
C2 OPTN
PROG
B2
SBC
RELAY A
RELAY B
DATA
14
13
12
11
10
9
8
7
6
5
4
3
2
1