Programming - Remote Controls - LiftMaster Contractor Série Guide De L'utilisateur

Operation

Programming - Remote Controls

Your garage door opener has been programmed at the factory to operate with your remote control. Older LiftMaster remote controls are NOT compatible. Programming can be done
through the door control or the Learn button on the garage door opener. To program additional remote controls refer to the instructions provided with the additional remote controls or visit
www.liftmaster.com. If your vehicle is equipped with a Homelink
additional information.
NOTE: The products illustrated in the instructions are for reference. Your product may look different.
PROGRAM USING THE GARAGE DOOR OPENER
1
Locate the Learn button.
ERASE ALL DEVICES (INCLUDING MYQ
1
Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2
Immediately press and hold the learn button again until the learn LED goes out. All codes
are now erased.
Reprogram any accessory you wish to use.
®
, you may require an external adapter depending on the make, model, and year of your vehicle. Visit www.homelink.com for
2
Press and immediately release the Learn
button. The Learn LED will glow steady for
30 seconds. Within 30 seconds...
® ENABLED ACCESSORIES)
3
Press and hold the button the remote control that you wish to use.
Release the button when the garage door opener lights blink or two clicks are heard.
If programming to other products, press the button a second time to activate products.
7