Using The Door Control - LiftMaster Contractor Série Guide De L'utilisateur

Operation

Using the Door Control

SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar or push
button until the garage door opener activates (it may take up to 3 presses). Test the door
control by pressing the push bar or push button, each press of the push bar or push
button will activate the garage door opener.
Push Bar
SERVICE LED
LEARN Button
LOCK Button
COMMAND LED
LIGHT Button
PUSH BAR OR PUSH BUTTON
Press the push bar or push button to open or close the door.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener lights on or off. When the lights are
turned on they will stay on until the LIGHT button is pressed again, or until the garage door
opener is activated. Once the garage door opener is activated the lights will turn off after
the specifi ed period of time (the factory setting is 4-1/2 minutes). The LIGHT button will not
control the lights when the door is in motion.
The following features are accessible by lifting up the push bar (multi-function door
control only):
LEARN A DEVICE
Any compatible remote controls or wireless keyless entries can be programmed to the
garage door opener by pressing the LEARN button on the Multi-Function Control Panel.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote
controls while still allowing activation from the door control and keyless entry. This feature is
useful for added peace of mind when the home is empty (i.e. vacation).
AUTOMATIC LIGHT
Light Feature
The lights will turn on when someone enters through the open garage door and the safety
Push
reversing sensor infrared beam is broken.
Button
Light
MAINTENANCE ALERT (MAS)
Button
This feature assists the homeowner in ensuring the garage door opener system stays in
good working condition. When the garage door opener needs to be serviced (approximately
4500 garage door opener cycles) the command (yellow) and service (red) LEDs will begin
to alternately fl ash back and forth. The factory setting for the MAS feature is off and can be
activated at time of installation. Contact your installing dealer for service.
Programming - Push Button Door Control
Push
Button
5
Feature
To Program 1. Press and hold the Light button and the
a Remote Push button until the Push button LED
Control or begins to blink.
Light
Button Keyless Entry
2. Remote Control: Press the button on the
remote control that you wish to operate
your garage door.
Keyless Entry: Enter a 4-digit personal
identifi cation number (PIN) of your
choice on the keyless entry keypad. Then
press the ENTER button.
The garage door opener lights will fl ash (or
two clicks will be heard) when the code has
been programmed.