Install The Door Control - LiftMaster 8010 Installation

Installation

10 Install the Door Control

To prevent possible SERIOUS INJURY or DEATH from electrocution:
Be sure power is NOT connected BEFORE installing door control.
l
Connect door control ONLY to 12 VOLT low voltage wires.
l
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
Install door control within sight of garage door, out of reach of children at a minimum height of 5
l
feet (1.5 m), and away from ALL moving parts of door.
NEVER permit children to operate or play with door control push buttons or remote control
l
transmitters.
Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no
l
obstructions to door travel.
ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross
l
path of closing garage door.
INTRODUCTION
Install the door control within sight of the door at a minimum height of 5 feet (1.5 m) where small children
cannot reach, and away from the moving parts of the door.
NOTE: Your product may look different than the illustrations.
Drywall Anchors (2)
HARDWARE
Insulated Staples
(Not Shown)
Screw 6ABx1" (2)
1. Strip 1/4" (6 mm) of insulation from one end of the wire and separate the wires.
2. Connect one wire to each of the two screws on the back of the door control. The wires can be
connected to either screw.
3. Mount the door control with the hardware provided.
1 2
1/4" (6 mm)
16
3