Maintenance; Maintenance Schedule; Every Month; Every Year - LiftMaster 8010 Installation

Maintenance

Maintenance Schedule

EVERY MONTH

Manually operate door. If it is unbalanced or binding, call a trained door systems technician.
l
Check to be sure door opens and closes fully. Adjust if necessary, see page 25.
l
Test the safety reversal system. Adjust if necessary, see page 26.
l

EVERY YEAR

Oil door rollers, bearings and hinges. The garage door opener does not require additional
l
lubrication. Do not grease the door tracks.

The Remote Control Battery

To prevent possible SERIOUS INJURY or DEATH:
NEVER allow small children near batteries.
l
If battery is swallowed, immediately notify doctor.
l
To reduce risk of fire, explosion or chemical burn:
Replace ONLY with 3V CR2032 coin batteries.
l
DO NOT recharge, disassemble, heat above 212°F (100°C) or incinerate.
l
The 3V CR2032 Lithium battery should produce power for up to 3 years. If
the battery is low, the remote control's LED will not flash when the button is
pressed.
To replace battery, pry open the case first in the middle (1), then at each
side (2 and 3) with the visor clip. Replace the batteries with only 3V
CR2032 coin cell batteries. Insert battery positive side up. Dispose of old
batteries properly.
NOTICE: Thisdevice complieswith Part 15 of the FCC rulesand IndustryCanada (IC) licence-exempt RSSstandard(s). Operation is
subject to the following two conditions: (1) thisdevice maynot cause harmfulinterference, and (2) thisdevice must accept any
interference received, including interference that maycause undesired operation.
Anychangesor modificationsnot expresslyapproved bythe partyresponsible for compliance could void the user'sauthorityto operate
the equipment.
ThisClassBdigitalapparatuscomplieswith Canadian ICES-003.
31
3
1
2