Overview Of Typical Installation - LiftMaster Elite Serie Manuel D'installation

Overview of Typical Installation

Check the national and local building codes BEFORE installation.
NOTE: One or more contact or non-contact external monitored entrapment protection systems shall be located where the risk of entrapment or obstruction
exists at either the opening or closing direction. Care shall be exercised to reduce the risk of nuisance tripping, such as when a vehicle trips the sensor
while the gate/door is still moving. See page 13 for installation of required entrapment protection devices.
Make sure the gate opens and closes smoothly.
Gate should stay in the open position when springs
are properly balanced.
Make sure the door opens and closes smoothly.
Door should stay in the open position when springs
are properly balanced.
Photoelectric Sensors
Illustrations are for reference only; your application may look different.
INTRODUCTION
Brackets (not provided)
Edge Sensor
Brackets (not provided)
Operator
8
Flush Mount
Operator
Warning Sign
Flush Mount
Warning Sign