Internal Elements; Ventilation; Storage - SCHUBERTH C3 Manuel

G. MAINTENANCE AND CARE

4. INTERNAL ELEMENTS

REPLACEABLE PARTS OF THE INTERNAL ELEMENTS
The head and cheek pads can be hand washed using a mild soap solution
(e.g. a highly diluted solution of mild detergent) at a maximum temperature
of 30 °C. After washing, allow the elements to dry at room temperature in a
well-ventilated area.
NON-REMOVABLE INTERNAL FABRIC ELEMENTS
The internal elements can be washed using a mild hand-warm soap solution
(e.g. a highly diluted mild detergent solution). Apply the detergent using a
moist sponge or cloth by dabbing or rubbing lightly. Do not rinse the interior
elements. Next, soak up the soap suds by dabbing the padding with a dry ab-
sorbent cloth. Repeat these steps with clean water. When drying the interior
of the helmet, ensure that it is well ventilated.

5. VENTILATION

VENTILATION HOOD
When necessary you can remove the air inlet hood of the head
ventilation system to clean the ventilation mechanism.
1. Remove the control element by simply
pulling it up out of the hood.
72
2. Now insert the flat end of the control
element under the edge behind the
hood and remove the hood by levering
it upward.
3. After cleaning, replace the air inlet
hood by hooking it onto the ventilation
system at the front and then pressing it
onto the helmet shell until an audible
click is heard.
4. Finally, re-insert the control element
through the hood into the mechanism.

6. STORAGE

Store the helmet in the bag supplied in a dry, well-vented and stable location.
Always put the helmet down in a place such that it cannot fall onto the floor.
Any damage that occurs in this way is not covered by the warranties.
Caution:
Keep the helmet out of reach of children and pets.
EN
73