JANE Nurse CUBE Instructions page 67

GB
SECURING YOUR BABY
6
• 6.1 Setting the shoulder belt height
• Check whether the shoulder belts are set at the right height for your child. The shoulder belts should be fed
into the belt slots that lie at shoulder height or just above.
• If the height of your shoulder belts in child car seat is not fit for your child. Adjust the height of the shoulder
belts, please proceed as follows:
• Step 1: loosen the shoulder harness (see point 6.2).
• Step 2: Pull out the buckle tongues from the chest pad and the slots on the cover and the shell, and then
thread them into the corresponding belt slots.
• Ensure that both of the shoulder belts go through slots at the same height, and not twisted.
• 6.2 Loosening the shoulder straps
• The shoulder straps are slackened by pressing the lever (under the seat cover) on the front of the seat.
• Press down on the label marked "press" as you grip the two shoulder straps with your other hand. Pull the
shoulder straps towards you to loosen it.
• 6.3 Securing the baby with the harness
• 1. Firstly adjust the shoulder straps height (see point 6.1), proceed as follows.
• 2. Loosen the harness (see point 6.2), open the buckle, and place them down sideways. Seat your child in
the child car seat. Place both shoulder straps over your child's shoulders.
• 3. Lock the buckle tightly.
• 4. Ensure that the straps are close to the should of the child by pulling the straps tightly.
• The harness should be adjusted as tightly as possible without causing discomfort to your child.
• It is dangerous not to tighten the straps. Check the adjuster and be sure that the straps are pulled tightly,
not twisted after install It each time.
• 6.4 The use of buckle
• 1. Put the two metal sections of the buckle connector's together (fig. 1).
• 2. Slot the two buckle connectors into the slot in the top of the buckle until they "click" into place (fig. 2).
• 3. Check the harness is correctly locked by pulling the shoulder straps upwards (fig. 3).
• 4. To release the harness, press the red button on the buckle downwards.
MAINTENANCE AND CLEANING
7
• 7.1 Take off the fabric cover
• Step 1: First pull out the harness from the seat.
• Step 2: Unfasten the bottles crew on the handle, and then take off the canopy from backwards.
• Step 3: Loosen the elastic you can take off the fabric cover from upwards.
• You can put on the canopy if you act the above steps in reversal ways.
• 7.2 Cleaning of the fabric cover
• Use only neutral detergent and warm water to wash. Do not wash by machine, spin-dry or tumble-dry are
not recommended.
• 7.3 Maintenance and cleaning
• 1. Please often check the function and spare parts of the baby car seat are in good condition to avoid
accident.
• 2. Before using, please check the locking fastness of the buckle by pulling in effort the straps and see
whether the buckle is loose or not.
• 3. Do not use the baby car seat in cold, wet or hot circumstance for long time.
THIS COVER SHOULD BE HAND WASH
PROCEDURE AFTER AN ACCIDENT
• The child car seat must be replaced when it has been subject to violent stresses in an accident.
INSTRUCTIONS
67