JANE Nurse CUBE Instructions page 29

GB
To convert from seat to cot
1) Adjust the backrest in most lying position (fig. 12-3).
2) Release the 3 sets of webbing buckles under leg rest zone and 1 set of webbing buckles under
headrest zone.
3) Press down with your hand to even the bottom.
4) Remove the front bumper.
5) remove the shoulder and waist harnesses from the buckle, put them away close to the sides of the
cot and cover them with a cover. Mat with thickness not more than 20mm.
WARNING! Do not put additional mattress thicker than 20mm in the carry cot!
To convert from cot to seat
1. Remove the cover/mat.
2. Lift the bottom to the armrests level.
3. Buckle up 3 sets of webbings under footrest area and 1 set of webbings under headrest area.
ATTENTION! NEVER REMOVE THE SOT FROM THE FRAME WHEN THERE IS A CHILD IN ITI!
WARNING! YOU MUST ALWAYS ENGAGE THE PARKING DEVICE ON THE REAR WHEELS BEFORE
REMOVING THE SEAT/COT FROM THE FRAME.
15 INSTALLING AND REMOVING CAR SEAT ON THE FRAME OF STROLLER , "2 IN 1"
The Frame of the stroller from set 2 IN 1 is compatible with car seat which is not part of this set and
can be purchased separately.
WARNING: Follow the given guidelines to install the car seat correctly and safely. Make sure that the
car seat is fixed to the stroller frame. Do not install the car seat while there is child in it.
ATTENTION! ALWAYS INSTALL THE CAR SEAT IN FACE-TO-FACE MODE!
Installing the car seat on the stroller frame
To install the car seat on the stroller frame, follow the below sequence of actions:
1) Engage the parking device;
2) Remove the seat from the stroller frame;
3) Set the car seat in a position so that it faces the parent, align the adaptors of the car seat with the
side openings in the frame and press down until you hear a click and the car seat is fixed.
4) Use the safety harnesses to secure the child.
Removing the car seat from the stroller frame
Set the handle in upright position and press simultaneously the release buttons on both sides of the
seat, after that remove the car seat from the stroller frame.
CONVERTIBLE HAMMOCK
16
a. Recline the hammock to the lowest position of the backrest and place the hammock in the rearward
facing position.
Open the zip on the hood to raise the hood up and tighten the side struts.
b. Release the clip behind the backrest.
c. Release the two clips behind the footrest.
d. Press the interior of the convertible hammock to leave the base of the carrycot in a flat, horizontal
position.
e. Extract the 5 points of the harness, removing all the buckles through the slots in the rear part of the
backrest.
To turn the carrycot back into a hammock, follow the same steps in reverse order. (figures 16a, 16b,
16c, 16d, 16e).
INSERT THE CAR SEAT
17
To attach the car seat
Attach the seat on the frame.
To remove the car seat
Press the buttons on both sides, then lift the carseat.
INSTRUCTIONS
29