JANE Nurse CUBE Instructions page 26

GB
UNFOLDING THE STROLLER
1
Place the frame on an even surface and release the frame locker (part. 15, fig. 1-1), which holds the frame
folded, (fig. 2-1 and 2). With one hand grab the stroller handle and pull up, while with the other hand
hold the support tube to unfold the frame (fig. 2-3). You must hear a click indicating that the stroller is
locked unfolded.
WARNING! Check if the stroller is locked in unfolded position!
INSTALLING AND REMOVING THE FRONT WHEELS. FUNCTIONS
2
Install with pressure each front wheel (pos. 9, fig. 1-1) in the front tubes of the frame until you hear a click
(fig. 3). Check whether the wheel is well fixed by pulling it down.
To detach the wheels from the frame, press the release button on the front wheels (fig. 3) and pull the
wheel out.
WARNING! Make sure that the front wheels are well installed and fixed to the stroller frame by moving
and turning them with your hand.
Straightforward mode of the front wheels (fig. 4-1)
The front wheels will move only straight when you press down the Front wheel locking button (pos. 7,
fig. 1 -1) on the front wheels.
You will hear a click when the straightforward mode is engaged.
Swiveling mode of the front wheels (fig. 4-2)
The front wheels will swivel when you press the Front wheel swivel button (pos. 8, fig. 1-1).
WARNING! The good working order of the buttons is crucial to the locking of the front wheels and the
safe use of the stroller.
WARNING! When you use the stroller on uneven surfaces, fix the front wheel. For even surfaces, please
use the swivel function. These two functions assure better moving of the stroller and so you will prevent
the wheels from wearing out or damaging soon.
3 INSTALLING AND REMOVING THE REAR WHEELS
Installing the rear wheels
Place the axis of each rear wheel in the respective opening in the frame as shown in fig. 5. Install with
pressure until you hear a click and the wheels are fixed.
WARNING! Make sure that the rear wheels are well installed and fixed to the stroller frame by moving
and turning them with your hand.
WARNING! Try to move and turn both front and rear wheels to make sure that they are well installed
and fixed to the frame.
Removing the rear wheels
To remove the rear wheels press with one hand the rear wheel release button (fig. 5-1), while with the
other hand pull the wheel out.
INSTALLING AND REMOVING THE SEAT TO THE STROLLER FRAME
4
The seat can be installed in two directions - forward facing or facing the parent.
Choose the desired direction and place the adaptors onto the respective openings on both sides of the
frame. Install with pressure until you hear a click and the seat is fixed (fig. 6).
WARNING! Before using the stroller make sure that the seat is correctly fixed to the frame by trying to
pull it up.
Removing the seat
To remove the seat from the frame press simultaneously the release buttons (pos3. 13, fig. 1-1 ) on both
sides of the seat (fig. 6) and pull it away from the frame.
FRONT BUMPER
5
Installing the front bumper
26
To install the front bumper (pos. 2, fig. 1-1), align its ends to the respective openings in the frame (fig. 7).