JANE Nurse CUBE Instructions page 66

GB
NOTICE
• 1 .This is a "Universal" child restraint. It is approved to Regulation No.44,04 series of amendments, for
general use in vehicles and it will fit most, but not all, car seats.
• 2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is
capable of accepting a "Universal "child restraint for this group.
• 3. This child restraint has been declared "Universal" under more stringent conditions than those applied to
earlier designs which do not carry this notice.
• 4. If in doubt, consult either the child restraint manufactured or the retailer.
• Only suitable if the vehicle is fitted with 3-point safety belts, approved to UN/ECE Regulation No. 16 or
other equivalent standards.
WARNING
• DO NOT place rear-facing child seat on front seats with airbags.
NOTES
• Please read through these instructions carefully before using the baby car seat for the first time. You risk
endangering your child's life if you use the product incorrectly
• 1. Applicability
• The baby car seat is suitable for weight categories 0+. Group 0+: Birth-13kg
AIRBAG
• DO NOT place this baby seat on seats with front airbags.
• Only suitable if the vehicle is fitted with 3-point static, 3-point retractor safety belts, approved to UN/ECE
Regulation No. 16 or other equivalent standards.
SNAPPED THE HANDLE
4
• The handle for the baby car seat can be snapped Into 4 stable positions.
• To adjust the handle, please press the red button of handle on both sides at the same time, now it can be
rotated.
• Adjust the handle of the baby car seat when locking to suitable position and check if it is locked well.
• Fig. 1: Installed In the car (Position when the vehicle is been driving).
• This position (only this position) is suitable for the baby car seat installed on the vehicle seat.
• Fig. 2: Straight up for carrying.
• Fig. 3: Handle clicked back to initiate the rocking feature.
• Fig. 4: Handle clicked down for a more upright sitting position, easy to feeding.
• Always ensure that the baby was fitted in the seat firmly by the harness, and the handle is locked in position.
5 SECURING THE INFANT CARRIER
• Please read the operating handbook in your vehicle to inform yourself about the basics concerning children's
seats in vehicles.
• DO NOT place this baby seat on seats with front airbags.
• This baby car seat can only be installed using a three-point vehicle belt.
• The baby car seat must be Installed rearwards facing (in the direction opposite the one in which you are
traveling).
• Step I. Adjust the handle to the forward position (Fig. 1).
• Step 2. Put the seat in car's seat (Fig. 2). Put the baby car seat against the backrest of the vehicle seat.
• Step 3. Slide the lap belt of the vehicle's 3-point seatbelt through both Lap belt guides. Let the tongue plate
snap in the belt lock with a clearly audible" click". Pull the shoulder belt in narrow direction to tighten the lap
belt. Check to make sure the tongue plate is locked by pulling on the belt (Fig. 3).
• Step 4. Place the diagonal belt in the diagonal belt guide at the back of the seat. Turn the handle of the seat
to the appropriate place in the car. (Hearing "click" is sure the handle has been locked and it should be firmly
against the backrest of car's seat.
ATTENTION:
• At back of the car seat, vehicle's belt route must be same as the pointed red-mark in fig. 6.
• Step 5. Tighten the vehicle's own 3-point seatbelt by pulling hard on the positions showed in fig. 5.
• Attention: The handle of the seat must be firmly against the backrest of car seat.
• You can release the child if you act the above steps in reversal ways.
• Make sure all the belts' position is right and they have not become twisted. Also check that the cover is not
impeding the movement or fit of the belt webbing in any way.
• The satisfactory position of the adult safety-belt buckle relative to the child car seat is as the Fig. 7. Fig. 8 is
incorrect.
66
• You can contact the child car seat manufacturer if in doubt about this point.