JANE Nurse CUBE Instructions page 27

GB
Install by pressing until the pins are visible through the respective openings in the frame and you hear
a click. Make sure the front bumper is well fixed to the frame.
Removing the front bumper
Press the front bumper release button (pos. 12, fig. 1) on one side and pull the bumper out (fig. 7). In this
way it will be easier to put the child in or take out of the stroller.
Press simultaneously both front bumper release buttons. Pull the bumper out to remove it from the
seat.
WARNING! Always use the front bumper with the safety harnesses when the child is in the stroller
ATTACHING AND REMOVING THE CANOPY
6
Attaching the canopy
Place the brackets on both sides of the canopy (pos 1, fig. 1-1) on to the handle tubes so that the pins
match the openings in the canopy brackets. Install with pressure until you hear a click and the pins show
through the openings in the brackets (fig. 8). Cover the backrest with the canopy and fix the canopy
with the Velcro straps.
WARNING! Always attach the end of the canopy to the seat backrest in order to prevent sliding of the
baby off the stroller.
Open the zipper in the rear side of the canopy to enlarge it. To open or close the canopy you must pull
it out or push it back until the desired position is reached.
Removing the canopy
To remove the canopy pull the two brackets out, open the Velcro straps and remove the canopy.
7 PARKING DEVICE
The stroller is equipped with a parking device (pos. 20, fig. 1-2), which block simultaneously both rear
wheels and the movement of the stroller.
Press the pedal on the right wheel with your foot (fig. 9) to block the movement of the stroller. Make sure
the parking device is engaged. The stroller should not move at a light push.
Lift the pedal up with your foot to release the parking device.
ATTENTION! When the stroller is not in motion, always use the parking device! If there is a baby in it,
never leave the stroller on a slope, even if the parking device is engaged!
ATTENTION! Always engage the parking device when putting in or taking your child out of the stroller,
as well as when you make adjustments, when folding or unfolding the stroller!
LEG REST
8
The leg rest (pos. 6, fig. 1-1) can be positioned in three levels.
To adjust the leg rest, press down both buttons on both sides of leg rest (pos. 5, fig, 1-1) and move it up
or down until you hear a click (fig. 10).
STORAGE BASKET
9
The storage basket (pos. 14, fig. 11-1) is closed (fig. 11-1). The opening is situated on one side of the
stroller. You can open (fig. 11-2) or close the basket (fig. 11-3) with a zipper.
WARNING! The maximum load in the storage basket must not exceed 3 kg. The load must be evenly
distributed. Do not overload!
ADJUSTING THE BACKREST
10
The backrest can be adjusted in 3 positions - sitting, half-lying, lying (fig. 12 -1, 2, 3).
To take the backrest one position down or to set it in lying position, press the back rest position adjus-
ters (pos. 21, fig. 1) located on both sides of the stroller frame (fig. 12-1). At the same time press the seat
back. Release the buttons to fix the position. You must hear a click.
To set the seat in a higher position lift the lever up (fig. 12-2). At the same time press the seat up to the
desired position.
WARNING! Do not change the backrest position while there is child in it. In case you decide to change
the position, the child must be sitting and not leaning on the backrest during the adjustment!
INSTRUCTIONS
27