Menu - VOLTCRAFT Gamma Check Pro Notice D'emploi

11. MENU

If there is no measurement, the device will show the mode "Auto" or "On".
In the operating mode "Auto", the device is switched off automatically after approx. 30 seconds. If measurements
are conducted, only the display will switch off in the operating mode "Auto". Pushing any button activates the display
again or switches the device on.
In operating mode "On", the device and the display remains permanently on during a measurement. After comple-
tion of all measurements, the device will switch to the operating mode "Auto" and switch off to save power. The
results of the last measurements are in the measured value storage and can be requested at any time.
To activate the menu, push the Menu button (3). Then you can call the submenus individually with the navigation
buttons "r" and "s" (2).
The main menu is structured in the following submenus:
• Dosimeter
• Pulse counter
• Pulse rate
• Measured value storage
• Settings (date, time, operating mode, signal encoder)
• Data logger (measured value storage with selectable scanning rate)
• Reset (to reset to the factory settings)
When you have called the desired submenu with the navigation buttons "r" and "s" (2), push the "OK" button (4)
to confirm. A flashing display with the current status of the selection made results.
The respective possible settings can be made as usually with the navigation buttons "r" and "s" (2) and are
confirmed with the "OK" button (4).
To leave the menu, a submenu or setting, push the Menu button (3) (repeatedly if necessary). This functions as a
return by one level/position here to be able to perform corrections if necessary.
All parameters chosen last are automatically saved in the device. You will receive these values as a sugges-
tion at the next start of a measurement.
All measured values and the date of the last completed dosimeter, pulse counter or pulse rate measurements
are also saved automatically. The bar display at the lower edge always shows the current memory utilisation.
All settings and the entire memory can be deleted in the menu item "Reset" (factory settings).
42