Pulse Rate Programme - VOLTCRAFT Gamma Check Pro Notice D'emploi

14. PULSE RATE PROGRAMME

The pulse rate determines all pulses per second within an adjustable duration and emits an alarm when an adjust-
able limit is exceeded.
Calling the Pulse Rate Settings
To call the pulse rate settings, push the Menu button (3); then use the navigation buttons "r" and "s" (2) to select
the display "
Push the "OK" button (4) to set the pulse rate.
Pulse Rate Time Settings
After the "OK" button (4) is pushed, the pulse rate display will start flashing and a clock symbol will appear. The
procedure or order of the inputs corresponds to the procedure in the dosimeter programme.
The duration of the measurement goes from one minute at minimum to 99 days, 23 hours and 59 minutes, i.e. just
under 100 days.
When the time is set up "00.00:00", the measurement will run for 10,000 days.
After setting the desired duration, push the "OK" button (4) to get to the next menu item.
Setting the limit for alarm
Here, you can set the limit for the alarm of 0.001 to 399.999 ticks per second (i.e. just under 400). Once this limit is
reached or exceeded, the device will emit an alarm.
The limit is set from the lowest-value digit using the navigation buttons "r" and "s" (2) and confirmed with the
"OK" button (4) (just as for the dosimeter programme).
48
OFF".
- RATE
- RATE
- RATE
1
s
MAX