VOLTCRAFT Gamma Check Pro Notice D'emploi page 45

Cancelling Measurements
For this, go to the menu until the display " On" appears and push the "OK" button (4). The symbol
" " and "On" flashes.
You can activate ("On") or deactivate ("OFF") the measurement with the navigation buttons "r" and "s". Select
"OFF" (flashes) and push the "OK" button (4), to cancel the measurement.
If you push the "OK" button (4) again, you can then enter new parameters. Returning/cancelling is possible here as
well using the Menu button (3).
After the end of the set time or when cancelling the measurement, the "Gamma Check Pro" will emit a signal for one
second.
If the limit for the alarm is exceeded during the measurement, the symbol "MAX" and the symbol of the measure-
ment will flash. The "Gamma Check Pro" emits an acoustic warning. This is repeated every 15 minutes until notice is
taken by pushing any button. The symbols stop flashing.
The measured value is displayed in µSv, mSv or Sv (depending on the measured value). Once the display exceeds
999999 Sv, the display shows "HIGH", since the value can no longer be displayed.
A measured value at this amount is possible because the dosimeter can be activated for 10,000 days.
45