Pulse Counter Programme - VOLTCRAFT Gamma Check Pro Notice D'emploi

13. PULSE COUNTER PROGRAMME

The pulse counter determines all pulses within an adjustable time and can emit an alarm when the adjustable limit
is exceeded.
Calling the Pulse Counter Settings
To call the pulse counter settings, push the Menu button (3); then use the navigation buttons "r" and "s" (2) to
select the display "
Push the "OK" button (4) to set the pulse counter.
Pulse Counter Time Settings
After the "OK" button (4) is pushed, the pulse counter display will start flashing and a clock symbol will appear. The
procedure or order of the inputs corresponds to the procedure in the dosimeter programme (see chapter 12).
The duration of the measurement goes from one minute at minimum to 99 days, 23 hours and 59 minutes, i.e. just
under 100 days.
When the time is set up "00.00:00", the measurement will run for 10,000 days.
After setting the desired duration, push the "OK" button (4) to get to the next menu item.
Setting the limit for alarm
Here, you can set the limit for the alarm of 1 to 999999 ticks. Once this limit is reached or exceeded, the device will
emit an alarm.
The limit is set from the lowest-value digit using the navigation buttons (2) and confirmed with the "OK" button (4)
(just as for the dosimeter programme).
46
OFF".
- COUNT
- COUNT
- COUNT
MAX