Signal Encoders - VOLTCRAFT Gamma Check Pro Notice D'emploi

When the USB cable is connected and data exchange is possible, the display will show the USB symbol.
When no measurement is active, the display shows "IDLE". This corresponds to the operating mode "On".
The selection of the operating mode "Auto" or "On" is possible here, but will only become active after the
USB connection has been disconnected.
The USB symbol will not appear in spite of a connection being present when the device is off or the charge
condition of the rechargeable battery is too low.
The charge display is always visible when the USB connection is present.
e) Signal Encoders
The "Gamma Check Pro" has an acoustic alarm. It serves to signal exceeded thresholds, pulses (ticks), to confirm
when a button is pushed and to report the start or end of a measurement.
The integrated signal encoder can be switched on and off in the menu "Settings". The signal encoder is deactivated
at delivery.
When the signal encoder is switched off, no pulses or pushes of a button will be acoustically confirmed.
Alarms are, however, always output for reasons of safety, and cannot be switched off!
When the signal encoder has been switched on, the device will emit a brief "tick" sound at every count impulse. It
will also confirm every push of a button. Activation of this function will increase the power intake, while the operating
time reduces.
Signal output
Switching on the device
Switching off the device
Push of a button
Rechargeable battery weak
Start measurement
Cancel measurement
Measurement ended
Pulse recognised
Limit exceeded
Short sound
2x short sound
Short sound
Long sound, repeat every 5 minutes, also in the deactivated condition
2x long sound
Sound for 1 second
Sound for 1 second
Very short "tick" sound
3x short sound, is repeated 3x (repetition every 15 minutes, until confirmation
by any key)
39