Engine Maintenance; Servicing The Air Cleaner; Replacing The Air Filter - Toro 22601 Manuel De L'opérateur

4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
Important: Pump grease in slowly and carefully
to prevent damage to the bearing seals.

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily
The cyclone air filter collects the largest contaminant
particles, which collect in the container. When you can
see a layer of dirt at the bottom of the container, clean
the cyclone housing, air channels, and air intake screen.
Servicing the Cyclone Air Filter
Service Interval: Every 50 hours
1. Remove the 3 screws holding the cyclone housing.
2. Remove the housing with the air intake screen and
remove the air channels.
1. Cyclone housing
2. Screw
Note: The air channels may remain in the upper
portion or follow along with the housing when
removed.
3. Clean the components. Use water, detergent and a
brush. Dry carefully.
4. Place the air channels in the cyclone housing.
5. Insert cyclone housing into position and make sure
it fits in the upper portion. Do not use force; align it
in place before fitting the screws.

Replacing the Air Filter

Service Interval: Every 200 hours
If the engine is low on power, produces black smoke or
runs unevenly, the air filter may be clogged.
1. Remove the wing nut and lift off the cyclone filter
with the air filter cowling (Figure 14).
14
Figure 13
3. Air channels
4. Cyclone housing with air
intake screen