Checking The Engine Oil Level - Toro 22602 Manuel D'installation

Checking the Engine Oil Level

1. Park the unit on a level surface and stop the engine.
2. Clean around the oil dipstick
3. Unscrew the oil dipstick and wipe the end clean.
4. Slide the oil dipstick fully into the crankcase. Do not thread it in.
5. Pull the oil dipstick out and look at the end. Oil should be to the top of the upper limit range.
Note: Running the engine with low oil level can cause engine damage. This type of damage is
not covered by Warranty.
The engine is equipped with and Oil Alert system that will automatically stop the engine before
the oil level falls below the safe limit. To avoid the inconvenience of an unexpected shutdown,
fill to the upper limit, and check the oil level regularly.
6. If the oil level is low, slowly pour only enough oil into crankcase to raise the level to the upper
limit.
Important: Do not overfill the crankcase with oil because the engine may be damaged.
7. Replace the oil dipstick.
1
2
1. Oil dipstick 2. Oil fill hole 3. Upper limit 4. Lower limit
3
4
14