Toro 22602 Manuel D'installation page 18

5. Swing the cutting blade to one side, then lower it
approximately 1/2" to 1" into the front-top corner
of the stump. Swing the cutting blade back and
forth, lowering the cutting blade approximately
1/2" to 1" before each sweep, until you have
removed the front portion of the stump to ground
level.
6. Raise the cutting blade until center of cutting blade
is just above top of the stump.
7. With the cutting blade off to one side, release the
parking brake and advance the machine forward,
reset the parking brake.
8. Sweep the cutting blade across the stump, cutting
away 1/2" to 1" of stump.
9. Advance the machine forward 1/2" to 1", and
sweep across the stump in the opposite direction.
10. Continue sweeping and cutting blade left and right
across stump, advancing the machine before each
sweep, cutting 1/2" to 1" depth of cut with each
sweep.
11. Continue cutting until top level of stump is all
removed, making sure not to cut stump deeper than
ground level during this first stage.
12. Move throttle to the DISENGAGE position, push
the handle down enough to raise the cutting wheel
off the ground. Wait ten seconds for blade to stop
rotating then release brake and retract machine
from stump.
17