Drive Belt; Drive Belt Adjustment - Toro 22602 Manuel D'installation

Drive Belt

The drive belt of the stump grinder is a double-banded 3V-belt.
Note: The belt tension should be checked daily.
Replace the belt if it shows any signs of wear,
cracks, or damage.
1. Shut off the engine and wait for all rotating
parts to stop.
2. Remove belt guard retaining screws.
3. To check belt tension, gently squeeze together.
You should be able to depress the belt down
about 1/4 - 3/8" (6-10mm) from the original
position.
Note: To extend belt life, proper tension must be
maintained. A loose belt will cause excessive
cutting blade slippage and early belt failure. A belt
that is too tight can cause bearing and shaft failure,
and rapid belt wear.

Drive Belt Adjustment

1. Loosen the 2 bolts behind the centrifugal
clutch.
2. Loosen the 4 engine mounting bolts.
3. Turn square head adjusting bolt on the frame
clockwise to tighten the belt, counter clockwise
to loosen the belt.
Important: Make sure to tighten all 6 bolts
after proper belt adjustment is achieved.
3. Install the belt guard and secure with
previously removed hardware.
28