Starting The Engine; Using The Self-Propel Drive; Stopping The Engine - Toro 20835 Mode D'emploi

Starting the Engine

1. Hold the blade-control bar
handle.
1. Blade-control bar
2. Pull the recoil-start handle
Note: If the machine does not start after several
attempts, contact an Authorized Service Dealer.
(Figure 14) against the
Figure 14
(Figure 15).
Figure 15

Using the Self-Propel Drive

To operate the self-propel drive, simply walk with your hands
on the upper handle and your elbows at your sides, and the
machine will automatically keep pace with you

Stopping the Engine

Service Interval: Before each use or daily—Ensure that
the engine stops within 3 seconds after
releasing the blade control bar.
To stop the engine, release the blade-control bar
Important: When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.
10
(Figure
Figure 16
(Figure
Figure 17
16).
17).