Recycling The Clippings; Bagging The Clippings; Rear-Discharging The Clippings - Toro 20835 Mode D'emploi

Recycling the Clippings

Model 20836 only
Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
Note: The grass bag may remain on the machine while you
are recycling the clippings.
To recycle the clippings, move the bag-on-demand lever to
the recycling mode (Figure
1. Recycling mode

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown toward you or
bystanders, resulting in serious personal injury or
death.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
18).
Figure 18
2. Bagging mode
1. Stop the engine and wait for all moving parts to stop.
2. Install the grass bag; refer to
(page 11) and move the bag-on-demand lever to the
bagging mode (model 20836 only) as shown in
18.
Installing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Raise and hold up the rear door, install the bag in the
notches, and lower the rear door
Removing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Lift up the grass bag up and away from the handle.
Note: Tilt the grass bag slightly backward to prevent
the collected grass clippings from falling out.
Rear-Discharging the
Clippings
Use the rear discharge for cutting very tall grass.
Note: If the grass bag is on the machine, remove it before
rear-discharging the clippings; refer to
Bag (page 11). The bag-on-demand lever should be in the
bagging mode (model 20836 only) as shown in
11
Removing the Grass Bag
(Figure 19).
Figure 19
Removing the Grass
Figure
Figure
18.