Cleaning; Removing Debris From The Machine - Toro 22601 Manuel De L'opérateur

Figure 22
3. Check each section for cracks. Replace a blade
section if it is cracked or has missing or worn teeth.
Note: When replacing cutting wheel blade sections,
make sure blade section is placed in correct
alignment with blade rotation.
4. Insert the blade section between the blade mounting
flanges (Figure 22), and secure them with 2 bolts,
lockwashers, and nuts.
5. Torque the fasteners to 27–33 ft-lb (37–45 N-m).

Cleaning

Removing Debris from the
Machine
Regular cleaning and washing will increase the life span
of the machine. Clean the machine directly after use,
before the dirt hardens.
Check before cleaning that the fuel tank cap is properly
in place to avoid getting water in the tank.
Use care when using a high-pressure sprayer because it
can damage warning decals, instruction signs, and the
engine
Important: Lubricate the cutting wheel blade
bearings after cleaning.
19