Maintenance And Storage - Toro 22601 Manuel De L'opérateur

• Use extra care when handling gasoline and other
fuels. They are flammable and vapors are explosive.
– Use only an approved container
– Never remove the gas cap or add fuel with the
engine running. Allow the engine to cool before
refueling. Do not smoke.
– Never refuel or drain the machine indoors.
• Check that the operator presence controls, safety
switches, and shields are attached and functioning
properly. Do not operate unless they are functioning
properly.
• Check that the cutting wheel has stopped rotating
when you reduce the throttle.
Operation
• Never run an engine in an enclosed area.
• Only operate in good light, keeping away from holes
and hidden hazards.
• Be sure all drives are in neutral before starting the
engine. Only start the engine from the operator's
position.
• Never operate with the guards not securely in place.
Be sure all interlocks are attached, adjusted properly,
and functioning properly.
• Do not change the engine governor setting or
overspeed the engine.
• Stop on level ground, lower the grinder, and shut
off the engine before leaving the operator's position
for any reason.
• Keep hands and feet away from the moving grinder
wheel and teeth.
• Look behind and down before backing up to be sure
of a clear path.
• Keep pets and bystanders away.
• Do not operate the machine under the influence of
alcohol or drugs.
• Use care when loading or unloading the machine
into a trailer or truck.
• Ensure that the area is clear of other people before
operating the machine. Stop the machine if anyone
enters the area.
• Never leave a running machine unattended. Always
stop the engine and verify the cutting wheels has
stopped rotating.
• Never jerk the controls; use a steady motion.
• Watch for traffic when operating near or crossing
roadways.
• Do not touch parts which may be hot from
operation. Allow them to cool before attempting to
maintain, adjust, or service.
• Ensure that you operate the machine in areas where
there are no obstacles in close proximity to the
operator. Failure to maintain adequate distance from
trees, walls, and other barriers may result in injury
as the machine backs up during operation if the
operator is not attentive to the surroundings. Only
operate the unit in areas where there is sufficient
clearance for the operator to safely maneuver the
product.
• Before grinding, have the area marked for
underground utilities, and do not grind in marked
areas.
• Locate the pinch point areas marked on the machine
and keep hands and feet away from these areas.
• Lightning can cause severe injury or death. If
lightning is seen or thunder is heard in the area, do
not operate the machine; seek shelter.

Maintenance and Storage

• Stop the engine. Wait for all movement to stop
before adjusting, cleaning, or repairing.
• Clean debris from the grinder, drives, mufflers, and
engine to help prevent fires. Clean up oil or fuel
spillage.
• Let the engine cool before storing and do not store
near flame.
• Do not store fuel near flames or drain indoors.
• Park the machine on level ground. Never allow
untrained personnel to service the machine.
• Carefully release pressure from components with
stored energy.
• Remove the spark plug wire before making any
repairs.
• Keep hands and feet away from moving parts. If
possible, do not make adjustments with the engine
running.
• Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
• Keep nuts and bolts tight. Keep equipment in good
condition.
• Never tamper with safety devices.
• Keep the machine free of grass, leaves, or other
debris build-up. Clean up oil or fuel spillage. Allow
the machine to cool before storing.
4