Toro 22601 Manuel De L'opérateur page 12

2
1
5
6
Figure 11
8. Raise the cutting wheel until center of cutting wheel
is just above top of the stump.
9. With the cutting wheel off to one side, release the
parking brake and advance the machine forward,
reset the parking brake.
10. Continue sweeping and cutting wheel left and right
across stump, advancing the machine before each
sweep, cutting 1/2 inch to 1 inch depth of cut with
each sweep.
11. Continue cutting until the top level of stump is all
removed, making sure not to cut stump deeper than
ground level during this first stage.
12. Release the throttle so that it is in disengaged
position, push the handle down enough to raise the
cutting wheel off the ground. Wait ten seconds for
the cutting wheel to stop rotating then release the
brake and pull the machine away from the stump.
13. Pull the machine away from the stump and rake the
chips away from the stump.
14. Move the machine to the front of the stump and set
the parking brake.
15. Hold the throttle against the handle so that it is in
engaged position, this will engage the centrifugal
clutch and the cutting wheel rotates.
16. Continue cutting until by repeating step 10 again
and again until the level of stump is deeper than
ground level as desired.
17. Stop the machine; refer to
Stopping the Engine (page 11).
4
3
7
8
g014502
Note: Do Not let the front of the unit touch the
ground until you are sure the cutting wheel has
stopped turning.
DANGER
A rotating cutting wheel is very dangerous and
can cut and amputate hands and feet.
Stay at the operating position and be sure that
the cutting wheel has come to a complete stop
before doing anything else.
12