Maintenance; Recommended Maintenance Schedule(S); Lubrication; Greasing The Machine - Toro 22601 Manuel De L'opérateur

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
Important: The machine may be tipped backward
or on its side to facilitate access for cleaning or
service, but no longer than 2 minutes. If the
machine is held in this position for too long, the
engine can be damaged by gasoline draining into

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 25 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Yearly or before storage
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.

Lubrication

Greasing the Machine

Service Interval: Before each use or daily
Grease Type: General-purpose grease.
1. Clean the grease fittings with a rag.
2. Connect a grease gun to each fitting.
3. Lubricate two fittings, one on each cutting wheel
bearing.
Maintenance Procedure
• Change the oil.
• Check the engine oil level.
• Grease the machine.
• Check the air filter.
• Check the cutting wheel blades.
• Remove debris from the machine.
• Check the drive belt tension.
• Service the air filter.
• Change the oil.
• Clean the sediment cup.
• Check the spark plugs.
• Replace the air filter.
• Change the oil.
• Clean the sediment cup.
the crankcase. Should this happen, perform an
extra oil change on the engine. Then turn the
engine over a few revolutions with the starter handle
before starting the engine again.
13
Figure 12