Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.4.7
Setting the time and date parameters
Fig. 8.33
Overview
The sub-menu TIME/DATE SETTINGS is used to set the following:
•
•
the Weekday
The value is input figure by figure.
1. The start for the MEASUREMENT PARAMETER SETTINGS or
TIME/DATE SETTINGS is carried out as in chapter: 8.4.1, or.
2. the enter button sets the time and date.
3. The display switches to TIME/DATE.
If there are no desired changes in this levelWEEKDAY. In order to adjust the time input
the first of four figures using the buttons
field will flash. Further figures must be inputted in an analogue manner. Press the NEXT
button to confirm. The date display will flash.
In order to adjust the date input the first of the four figures using the buttons
Then press enter ↵. Then the second field will flash. Further figures must be input in an
analogue manner. Press NEXT to confirm.
417101555_CoolProtect.doc
. Then press enter ↵. Then the second
or
- 69 -
8.4.7
(overview diagram).
or
.
Rev.: 08-06/10
Publicité
Table des Matières
