Measuring Parameters - Ecolab MULTRONIC Manuel Technique

NOTE
Through selecting the module selection function one returns to configuration module
selection.
The first page of the redox module configuration menu is opened through selecting
page 1.
4.2

Measuring parameters

The main menu for adjusting the Multronic is accessed through operating the ↑ key in
the measuring mask.
Main menu
The measurement parameters are selected through placing the cursor onto the
selected item and operating the ENTER key.
Measurement
parameter module
selection
(not available at
Multronic OC!)
The redox measuring module that is to be parametered can now be selected. To do so,
move the cursor onto the corresponding selected item and operate the ENTER key.
The following measurement parameters of the redox measuring module can be
adjusted.
Measurement
parameter redox
The line labelled measuring range is for information purposes only. The measuring
range must not be changed.
The settings for the current signal function are distributed on two lines.
The lower limit of the current signal can be adjusted in the first line.
The minimum output current can be adjusted between 0 mA and 4 mA in the first
position. The second position (activated with →-key from the first position) is used
specify the minimum output current that is allocated to the measured value.
The second line is used to specify the measured value allocation for the maximum
output current (20 mA).
Respective value range: 0 mV to 1000 mV
417101806_Anhang04_Redox.doc
The time periods for the controllers must be within realistic limits.
min. controller on-time < controller cycle time < max. metering time
Redox Measuring Module
- 32 - Rev.: 06-07/10