Manual Functions; Access Code Functions - Ecolab CoolPROTECT Notice Technique

8.3.2

Manual Functions

Fig. 8.6
Via the menu MANUAL FUNCTIONS the outputs for the bleeding, biocide metering and
alarm can be activated manually.
In the sub menu MANUAL FUNCTIONS the manual settings of all outputs remain effective.
Only upon exiting the sub menu all manually set outputs will be reset.
8.3.3

Access code functions

The CoolPROTECT is equipped with protection to prevent unauthorized acess to the
service, parameter and configuration levels. The access code is activated it is only if
possible to enter these levels by input of a four digit number code.
When the entry code was inputted, there is a timespan of 15 minutes to change the
NOTE
settings. After this time is elapsed the code has to be reentered.
8.3.3.1 Entry into the access code functions
Activate the menu ACCESS CODE as per the programming structure chapter 8.3.1.
8.3.3.2 Display screens when changing into the menu level
If the access code is activated, the display screen shows:
(see also chapter 8.3.3.4)
When the entry code is deactivated, the display screen
shows:
(see also chapter 8.3.3.3)
417101555_CoolProtect.doc - 54 -
Fig. 8.7
Fig. 8.8
Rev.: 08-06/10