8.3.3.3 Activate access code (if it was deactivated before)
Fig. 8.9 Overview
1.
Carry out entry to the access code functions as in chapter: 8.3.3.1.
2.
The display shows: ACTIVATE ACCESS CODE
Execute code request with „Enter-Key ↵". INPUT CODE
3.
Enter the first of the four code numbers by utilizing this
Next press the Enter-Key ↵. Then the second field will flash.
The following three digits are to be entered analogously.
1.
Press the NEXT-Key to confirm.
4.
If the entered code is wrong, the display shows WRONG CODE NUMBER.
This display is confirmed by the NEXT-Key and leads back to the display
ACTIVATE ACCESS CODE. If the right access code was entered, the display
shows DEACTIVATE ACCESS CODE.
5.
Pressing the„NEXT-Key" leads to the function CHANGE ACCESS CODE.
6.
Pressing the „NEXT-Key" one more time leads back to the ACCESS CODE
FUNCTIONS.
417101555_CoolProtect.doc
- 55 -
or
this key.
Rev.: 08-06/10