Operating The Front Caster; Cleaning A Clogged Tip - Titan PowrLiner 2850 Mode D'emploi

OPERATION
4.6

OPERATING THE FRONT CASTER

The front caster on the cart is designed to track
i
the sprayer in either a straight line or allow free
motion.
Standing behind the sprayer, the trigger on the
left handle of the cart controls the operation of
the front caster.
1. To lock the front caster in the straight line position,
squeeze then release the caster trigger and move the
sprayer forward.
2. To allow free motion of the front caster, squeeze and hold
the caster trigger.
16
4.7

CLEANING A CLOGGED TIP

If the spray pattern becomes distorted or stops
i
completely while pulling the trigger, perform the
steps below.
1. Turn the relief valve to PRIME (k circulation).
2. If the tip clogs, rotate the tip handle 180° until the arrow on
the handle is facing the opposite of the spray direction and
the handle clicks in the reverse position (Fig. 13).
3. Turn the relief valve to SPRAY (p spray).
4. Trigger the gun once so that the pressure can blow the
clog out. NEVER use the tip in the reverse position for
more than ONE trigger pull at a time. This procedure can
be repeated until the tip is free of clogging.
The flow from the spray tip is at very high
pressure. Contact with any body part may be
dangerous. Do not place finger on gun outlet.
Do not point the gun at any person. Never
operate the spray gun without the proper tip
guard.
PL2850