Operation; Operating The Swing Cart - Titan PT6900 Plus DI 120V Mode D'emploi

Operation

4. Operation
This equipment produces a fluid stream at extremely
high pressure. Read and understand the warnings
in the Safety Precautions section at the front of this
manual before operating this equipment.
4.1

Operating the swing cart

Use caution when operating the swing cart. Keep
fingers and feet clear of moving parts.
The swing cart allows the motor/pump assembly to be rotated
between two positions.
Position #1: Working Position
The vertical position of the motor/pump assembly is the working
position. This position allows complete submersion of the siphon
tube on the fluid section into a paint bucket. The maximum height
paint bucket that can be used is 28 1/8" (71.4 cm).
Position #2: Transporting Position
The horizontal position of the motor/pump assembly is the
transporting position. This position allows easy removal of the
paint bucket and a sprayer height of 30" (76.2 cm) for ease of
transportation.
GB
Use the following procedure to change the position of the motor/
pump assembly.
1. Holding the handle grip (Fig 3, item 1) with one hand, pull
the locking pin (2) out of the locking hole on the cart with the
other hand. This allows the motor/pump assembly mounted
on the swing cart frame to move from one position to the
other.
2. Let go of the locking pin (2) once it is free of the locking hole.
3. Move the motor/pump assembly to the desired position. The
locking pin is spring loaded and will automatically engage the
locking hole on the swing cart at the new position.
2
1
10 PowrTwin Plus DI