Technical Data; Transportation In Vehicle; Starting Operation; High-Pressure Hose, Spray Gun And Separating Oil - Titan Performance 450e Série Mode D'emploi

Description of unit
3.5

Technical data

Voltage:
Max. current consumption:
Power cord:
Acceptance capacity:
Max. operating pressure:
Volume flow at 12 MPa
(120 bar) with water:
Max tip size:
Max. temperature of the
coating material:
Max viscosity:
Weight:
Special high-pressure hose: 6,35 mm, 15 m-18 NPSM
Dimensions (L X W X H):
Vibration:
Max sound pressure level:
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6

Transportation in vehicle

Secure the unit with a suitable fastening.
4.

Starting operation

4.1 High-pressure hose, spray gun and
separating oil
1. Screw the pressure gauge (1) to the coating material
outlet (Fig. 2, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet on the pressure gauge (Fig. 2, Item 4).
3. Screw the spray gun (5) with the selected tip onto the
high-pressure hose.
4. Tighten the union nuts at the high-pressure hoses firmly
so that coating material does not leak.
1
4
2
3
220~240 Volt AC, 50/60 Hz
5.5 A @ 230VAC
3 x 1.5 mm – 6 m
2
900 Watt
214 bar (21.4 MPa)
1.62 l/min
0.021 inch – 0.53 mm
43°C
20.000 MPa·s
15.2 kg
480 x 360 x 405 mm
Spray gun does not
exceed 2.5m/s 2
80 dB (A) *
GB
5. Fill the oil cup with Piston Lube (Fig. 3). Do not use too
much Piston Lube, i.e. ensure that no Piston Lube drips
into the coating material container.
Piston Lube prevents increased wear and tear to
the packings.
Attention
4.2

Connection to the mains network

The unit must be connected to an appropriately-
grounded safety outlet.
Attention
Before connecting the unit to the mains supply, ensure that the
line voltage matches that specified on the unit's rating plate.
4.3 Cleaning preserving agent when starting-
up of operation initially
1. Depending on the model, swivel or immerse the suction
tube (Fig. 4 Item 2) or the suction hose and return hose (1)
into a container with a suitable cleaning agent.
5
2. Turn the pressure control knob counterclockwise (3) to
minimum pressure.
3. Open the relief valve (4), valve position PRIME
(k circulation).
4. Switch the unit (5) ON.
5. Wait until the cleaning agent exudes from the return hose.
6. Close the relief valve, valve position SPRAY (p spray).
7. Pull the trigger of the spray gun.
8. Spray the cleaning agent from the unit into an open
collecting container.
24
Starting operation
Performance Series 450e