Technical Data; Transportation - Titan ELITE 4500 2407310 Mode D'emploi

ELITE 4500
3.5

TECHNICAL DATA

Gasoline engine, power
Fuel capacity
Max. operating pressure
Max. volume flow
Volume flow at 0.6 MPa (6 bar) with water
Max. temperature of the coating material
Material hose connection
Max. viscosity
Max. size of tip with a spray gun
1-Gun
2-Gun
Empty weight
High cart
Low cart
Dimensions (L x W x H)
High cart
Low cart
Hydraulic oil filling quantity
Hydraulics housing
Max. vibration at the spray gun
Max. sound pressure level
* Place of measurement: 1 m distance from unit and
1.60m above floor, 12 MPa (120 bar) operating pressure,
reverberant floor
160cc, 4.9 Hp
0.66 US gal (2.5 l)
3300 PSI (22,8 MPa, 228 bar)
1.25 gal/min (4.7 l/min)
1.59 gal/min (6.01 l/min)
109˚ F (43 ˚C)
1/4"-18 NPSM
20,000 mPas
0.035" – 0.89 mm
0.023" – 0.58 mm
112 lbs (50.8 kg)
104 lbs (47.2 kg)
77.5 cm x 62.7 cm x 111.4 cm
127.3 cm x 64.3 cm x 59 cm
1.10 liter
lower than 2.5 m/s²
85 dB (A)*
OPERATING TEMPERATURE
This equipment will operate correctly in its intended ambient,
at a minimum between +50ºF (10°C) and 104ºF (+40°C).
RELATIVE HUMIDITY
The equipment will operate correctly within an environment
at 50% RH, 104ºF (+40°C). Higher RH may be allowed at lower
temperatures.
Measures shall be taken by the Purchaser to avoid the harmful
effects of occasional condensation.
ALTITUDE
This equipment will operate correctly up to 2100 m above
mean sea level.
Honda service center can add a high-altitude kit
i
if operation at higher elevation is required.
TRANSPORTATION AND STORAGE
This equipment will withstand, or has been protected against,
transportation and storage temperatures of -13ºF (-25°C) to
131ºF (+55°C) and for short periods up to 150ºF (+70°C).
It has been packaged to prevent damage from the effects of
normal humidity, vibration and shock.
3.6

TRANSPORTATION

TRANSPORTATION IN VEHICLE
Secure the unit with a suitable fastening.
PUSHING OR PULLING THE UNIT
Pull out the handle (Fig. 5, Item 1) until it will come no further.
Insert the handle – push the buttons (2) on the cart, and then
push in the handle.
1
2
DESCRIPTION OF UNIT
11