Technical Data; Transportation; Transportation In Vehicle; Starting Operation - Titan 750e Série Mode D'emploi

Description of unit
3.5

Technical data

Voltage:
Max. current consumption:
Power cord:
Acceptance capacity:
Max. operating pressure:
Volume flow at 12 MPa
(120 bar) with water:
Max tip size:
Max. temperature of the
coating material:
Max viscosity:
Weight:
Stand:
Cart:
Special high-pressure hose: 6,35 mm, 15 m-18 NPSM
Dimensions (L X W X H):
Stand:
Cart:
Vibration:
Max sound pressure level:
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6

Transportation

Pushing or pulling the unit
Pull out the handle (Fig. 2, Item 1) until it will come no further.
Insert the handle – push the buttons (2) on the spars, and then
push in the handle.
2
3.7

Transportation in vehicle

Secure the unit with a suitable fastening.
220~240 Volt AC, 50/60 Hz
6.6 A @ 230VAC
3 x 1.5 mm – 6 m
2
950 Watt
214 bar (21,4 MPa)
2.46 l/min
0.027 inch – 0.68 mm
43°C
25.000 mPa·s
21.2 kg
29.5 kg
480 x 360 x 405 mm
615 x 530 x 730 mm
Spray gun does not
exceed 2.5m/s
2
80 dB (A) *
1
2
GB
4.

Starting operation

4.1 High-pressure hose, spray gun and
separating oil
1. Screw the pressure gauge (1) to the coating material
outlet (Fig. 3, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet on the pressure gauge (Fig. 3, Item 4).
3. Screw the spray gun (5) with the selected tip onto the
high-pressure hose.
4. Tighten the union nuts at the high-pressure hoses firmly
so that coating material does not leak.
1
4
2
3
5. Fill the oil cup with Piston Lube (Fig. 4). Do not use too
much Piston Lube, i.e. ensure that no Piston Lube drips
into the coating material container.
Piston Lube prevents increased wear and tear to
the packings.
Attention
24
Starting operation
5
Performance Series 750e