Technical Data; Operator Controls - Titan PowrLiner 550 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.4

Technical data

Gasoline engine, power
Fuel Capacity
Max. operating pressure
Max. sound pressure level
Max. size of tip with a spray gun
Traffic marking
Field marking
Max. volume flow
Weight
Max. viscosity
Dimensions L x W x H
Altitude
Max. temperature of the coating material
Max. tire pressure
Special high-pressure hose
* Place of measurement: 1 m distance from unit and 1.60
m above reverberant floor, 120 bar (12 MPa) operating
pressure.
Do not remove the spray gun from the gun
holder and attempt to use it independently.
Doing this will will engage the safety shut-off
Attention
switch.
PowrLiner 550
PL550
37.7cc, 4-stroke gas engine
0,65 L
17,2 MPa (172 bar)
92 dB*
0,019" – 0,48 mm
0,023" – 0,58 mm
1,25 l/min
29,5 kg
20.000 mPa·s
104 cm x 53,3 cm x 81,3 cm
This equipment will operate
correctly up to 2000 m above
mean sea level
43° C
0,2 MPa (2 bar)
DN 6 mm, 15 m (50' x 1/4"),
connection thread NPSM 1/4
GB
3.5

Operator controls

The following section describes the operator controls on the
spray gun and line striper.
Spray Gun Trigger Lock
Engage the trigger lock whenever the gun is not in use.
The gun is locked when the trigger lock is at a 90º angle
(perpendicular to the trigger in either direction).
i
If necessary, loosen the gun holder clamp knob
and then engage the spray gun trigger lock.
Move the spray gun to its original position and
tighten the clamp knob.
Spray Lever
The spray lever is a dual-function lever. It is located on the cart
handle (fig. 4, item 1).
1
The spray lever controls the throttle on the engine as well as
the trigger on the spray gun.
Pulling the spray lever will simultaneously trigger the spray
gun as well as rev up the engine. This engages the engine
clutch with the pump and causes the sprayer to build
pressure.
i
The sprayer is equipped with an automatic
safety shut-off switch to prevent the sprayer
from over-pressurizing. When the relief valve is
in the SPRAY (
the spray lever half way without triggering
the spray gun will engage the safety shut-off
switch. Refer to the Maintenance section if the
safety shut-off switch engages.
9
Description of unit
p
) position , pulling and holding

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

0290004

Table des Matières