Hazard: Explosion Or Fire - Titan PowrLiner 550 Mode D'emploi

HAZARD: HIGH PRESSURE HOSE
The paint hose can develop leaks
from wear, kinking and abuse. A
leak can inject material into the skin.
Inspect the hose before each use.
PREVENTION:
• Avoid sharp bending or kinking of the
high-pressure hose. The smallest bending
radius amounts to about 20 cm.
• Do not drive over the high-pressure hose.
Protect against sharp objects and edges.
• Replace any damaged high-pressure hose
immediately.
• Never repair defective high-pressure hoses
yourself!
• Electrostatic charging of spray guns and
the high-pressure hose is discharged
through the high-pressure hose. For this
reason the electric resistance between the
connections of the high-pressure hose
must be equal to or lower than 1MΩ.
• For reasons of function, safety and
durability use only original Titan high-
pressure hoses.
• Before each use, check all hoses for cuts,
leaks, abrasion or bulging of cover. Check
for damage or movement of couplings.
Immediately replace the hose if any of
these conditions exist. Never repair a paint
hose. Replace it with another earthed high-
pressure hose.
• Make sure power cord, air hose and spray
hoses are routed in such a manner to
minimize slip, trip and fall hazard.
PowrLiner 550
GB

HAZARD: EXPLOSION OR FIRE

Flammable vapors, such as solvent
and paint vapors, in work area can
ignite or explode.
PREVENTION:
• Use equipment only in well ventilated area.
Keep a good supply of fresh air moving
through the area to keep the air within
the spray area free from accumulation of
flammable vapors. Keep pump assembly
in well ventilated area. Do not spray pump
assembly.
• Gas models only - Do not fill fuel tank while
engine is running or hot; shut off engine
and allow to cool. Fuel is flammable and
can ignite or explode if spilled on a hot
surface.
• Eliminate all ignition sources, such as pilot
lights, cigarettes, portable electric lamps
and plastic drop cloths (potential static
arc).
• Keep work area free of debris, including
solvent, rags and gasoline.
• Do not plug or unplug power cords, or turn
power or light switches on or off when
flammable vapors are present.
• Ground equipment and conductive objects
in work area. Make sure grounding chain is
in place and reaches the ground.
• Use only grounded hoses.
• Hold spray gun firmly to the side of a
grounded pail when triggering into pail.
• If there is static sparking or if you feel a
shock, stop operation immediately.
• Know the contents of the paint and
solvents being sprayed. Read all Material
Safety Data Sheets (MSDS) and container
labels provided with the paints and
solvents. Follow the paint and solvent
manufacturer's safety instructions.
• Do not use a paint or solvent containing
halogenated hydrocarbons. Such as
chlorine, bleach, mildewcide, methylene
chloride and trichloroethane. They are not
compatible with aluminum. Contact the
coating supplier about compatibility of
material with aluminum.
• Keep a fire extinguisher in work area.
3
Safety precautions