Attaching The Tip Guard And Tip; Pressure Relief Procedure - Titan PowrLiner 550 Mode D'emploi

POSSIBLE INJECTION HAZARD. Do not spray
without the tip guard in place. Never trigger
the gun unless the tip is in either the spray or
the unclog position. Always engage the gun
trigger lock before removing, replacing or
cleaning tip.
20. Start the engine.
21. Turn the relief valve knob to the SPRAY (
22. Fully pull the spray lever on the cart handle to rev the
engine, pressurize the sprayer, and trigger the spray
gun. Test the spray pattern and line position on a long
piece of roofing felt or cardboard. Check for proper line
width and position. If adjustment to the position of the
spray gun is required, refer to the "Setup" procedure
earlier in this section.
23. Make sure that the spray gun shuts off completely when
the gun trigger is released. If adjustment to the trigger
tension is required, refer to the "Adjusting the Trigger
Tension" procedure in the Maintenance section of this
manual.
24. Begin striping.
a. Position the line striper slightly in front of the striping path.
b. Start walking with the line striper and trigger the gun at the
beginning of the striping path.
c. At the end of striping path, release the trigger and continue
walking a short distance, if possible.
Triggering the gun after the line striper is
i
moving and releasing the trigger before the
line striper stops produces an evenly painted
line from start to finish. If the striping path
ends at an obstacle, release the trigger at
the same moment that the line striper stops
moving.
PowrLiner 550
GB
4.4
Use the following procedure to install the tip guard and tip to
the spray gun.
1. Perform the "Pressure Relief Procedure" described in
2. Using a pen or similar object, insert the tip seal (3) and
p
) position.
3. Insert the tip (1) into the slot on the tip guard.
4. Thread the tip guard onto the gun. Position the tip
i
4.5
1. Lock the gun by turning the gun trigger lock to the
2. Turn the relief valve knob to the PRIME (
3. Turn off the sprayer by pressing and holding the engine
4. Unlock the gun by turning the gun trigger lock to the
5. Fully pull the spray lever on the cart handle to trigger
6. Lock the gun by turning the gun trigger lock to the
13

Attaching the tip guard and tip

this manual (section 4.5).
seal (4) into the back of the tip guard (2). Press in for
final adjustment.
1
guard in the desired spraying position, then tighten
securely.
The arrow on the tip handle should be pointing
in the forward direction for spraying.

Pressure Relief Procedure

Be sure to follow the Pressure Relief Procedure
when shutting the unit down for any purpose,
including servicing or adjusting any part of
the spray system, changing or cleaning spray
nozzles, or preparing for cleanup.
locked position. If necessary, loosen the gun holder
clamp knob and then engage the spray gun trigger lock.
Move the spray gun to its original position and tighten
the clamp knob.
shutoff switch until the motor shuts off.
unlocked position.
the spray gun and release any remaining pressure in the
hose.
locked position. If necessary, loosen the gun holder
clamp knob and then engage the spray gun trigger lock.
Move the spray gun to its original position and tighten
the clamp knob.
Operation
2
4
3
k
) position.