Stenciling; Operating The Front Caster; Cleanup; Special Cleanup Instructions For Use With Flammable Solvents - Titan PowrLiner 550 Mode D'emploi

Operation
4.8

Stenciling

Do not remove the spray gun from the gun
holder and attempt to use it independently.
Doing this will will engage the safety shut-off
switch.
Attention
The spray gun cannot be removed from the gun holder to
perform stencil work. To stencil with this line striper, make
multiple spraying passes from right to left over the stencil.
4.9

Operating the Front Caster

The front caster on the cart is designed to track the sprayer
in either a straight line or allow a desired radius to be set. To
adjust the front caster:
1. Loosen the two caster bolts on the top side of the
caster.
2. Move the front wheel to the proper position for the
desired radius.
3. Re-tighten the bolts to secure the caster in position.
5.

Cleanup

The sprayer, hose, and gun should be cleaned
thoroughly after daily use. Failure to do so
permits material to build up, seriously affecting
Attention
the performance of the unit.
Always spray at minimum pressure with the
gun nozzle tip removed when using mineral
spirits or any other solvent to clean the sprayer,
hose, or gun. Static electricity buildup may
result in a fire or explosion in the presence of
flammable vapors.
5.1 Special cleanup instructions for use with
flammable solvents
• Always flush spray gun preferably outside and at least
one hose length from spray pump.
• If collecting flushed solvents in a one gallon metal
container, place it into an empty five gallon container,
then flush solvents.
• Area must be free of flammable vapors.
• Follow all cleanup instructions.
PowrLiner 550
GB
5.2
1
Attention
Attention
15

Cleaning the sprayer

1. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual, section 4.5.
2. Remove the gun tip and tip guard and clean with a
brush using the appropriate solvent.
3. Place the siphon tube into a container of the
appropriate solvent (refer to recommendations of the
material manufacturer). An example of the appropriate
solvent is water for latex paint.
4. Place the return hose into a metal waste container.
5. Turn the relief valve knob to the PRIME (
6. Start the engine.
7. Fluid will begin flowing through the return hose and
into the waste container. Allow the fluid to circulate
through the sprayer and flush the paint out of the
return hose into the metal waste container.
8. Turn off the sprayer by pressing and holding the engine
shutoff switch until the motor shuts off.
9. Place a metal waste container underneath the spray
gun to catch the paint and solvent.
10. Start the engine.
11. Turn the relief valve knob to the SPRAY (
12. Fully pull the spray lever on the cart handle to rev the
engine, pressurize the sprayer, and trigger the spray
gun. Fluid will begin flowing through the spray hose
and out of the gun.
13. Continue to pull the spray lever on the cart handle until
the material is flushed out of the hose and the solvent
coming out of the gun is clean.
14. Release the spray lever.
i
For long-term or cold weather storage, pump
Pump Saver™ through the entire system.
15. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual.
16. Store the sprayer in a clean, dry area.
Do not store the unit under pressure.
Do not put the high-pressure hose into
solvents. Use only a wet cloth to wipe down the
outside of the hose.
Cleanup
k
) position.
p
) position.