Explosion Protection - Titan Control Max 1900 Pro Skid Mode D'emploi

GB

Explosion protection

Do not use the unit in work places which are covered to the explosion protection regulations.
Danger
Danger of explosion and ire through sources of lame during spraying work
There may be no sources of lame such as, for example, open ires, smoking of cigarettes, cigars or tobacco
pipes, sparks, glowing wires, hot surfaces, etc. in the vicinity.
Danger
Electrostatic charging (formation of sparks or lame)
Under certain circumstances, electrostatic charging can occur on the unit due to the rate of low of the
coating material when spraying. On discharging this can result in the emergence of sparks or ire. It is
therefore necessary that the unit is always earthed through the electrical installation. The connection must
take place through a correctly earthed two-pole-and-earth socket outlet.
Danger
Ventilation
Good natural or artiicial ventilation must be ensured in order to avoid the risk of explosion or ire and damage to health during
spray work.
Secure device and spray gun
All hoses, ittings, and ilter parts must be secured before operating spray pump. Unsecured parts can eject at great force
or leak a high pressure luid stream causing severe injury.
Always secure the spray gun when mounting or dismounting the nozzle and in case of interruption to work.
Recoil of spray gun
In case of high operating pressure, pulling the trigger can efect a recoil force of up to 15 N.
If you are not prepared for this, your hand can be thrust backwards or your balance lost. This can lead to
injury.
Continuous stress from this recoil can cause permanent damage to health.
Danger
Max. operating pressure
Max. permissible operating pressure for spray gun, spray gun accessories and high-pressure hose may not fall short of
the maximum operating pressure of 110 bar (11 MPa) stated on the unit.
Coating substance
Caution against dangers that can arise from the sprayed substance and observe the text and information on the containers or the
speciications given by the substance manufacturer.
Do not spray any liquid of unknown hazard potential.
High-pressure hose (safety note)
Attention, danger of injury by injection! Wear and tear and kinks as well as usage that is not appropriate to
the purpose of the device can cause leakages to form in the high-pressure hose. Liquid can be injected into
the skin through a leakage.
Danger
High-pressure hoses must be checked thoroughly before they are used.
Replace any damaged high-pressure hose immediately.
Never repair defective high-pressure hoses yourself!
Avoid sharp bends and folds: the smallest bending radius is about 20 cm.
Do not drive over the high-pressure hose. Protect against sharp objects and edges.
Never pull on the high-pressure hose to move the device.
Do not twist the high-pressure hose.
1 8
Control Max 1900 Pro Skid